| Last Modified: 11-29-2007 | 1.6 J | |
| Service Category: Audio/Visual/Telematics | Section: Navigation/Multi Info Display | |
| Model Year: 2008 | Model: Sequoia | Doc ID: RM000002ZYT005X |
| Title: NAVIGATION / MULTI INFO DISPLAY: NAVIGATION SYSTEM: DESCRIPTION (2008 Sequoia) | ||
|
Sound Signal Circuit between Navigation Receiver Assembly and Stereo Jack Adapter |
DESCRIPTION
The stereo jack adapter assembly sends an external device sound signal to the navigation receiver assembly through this circuit. The sound signal that has been sent is amplified by stereo component amplifier assembly, and then is sent to speakers.
If there is an open or short in the circuit, sound cannot be heard from the speakers even if there is no malfunction in the stereo component amplifier assembly, navigation receiver assembly, or speakers.
WIRING DIAGRAM
INSPECTION PROCEDURE
PROCEDURE
|
1. |
CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER - STEREO JACK ADAPTER) |
|
(a) Disconnect the I5 navigation receiver assembly connector. |
(b) Disconnect the H7 stereo jack adapter assembly connector.
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
|
Tester Connection |
Condition |
Specified Condition |
|---|---|---|
|
I5-3 (VAL+) - H7-1 (ALO) |
Always |
Below 1 Ω |
|
I5-2 (VAR+) - H7-2 (ARO) |
||
|
I5-5 (VA-) - H7-3 (ASGN) |
||
|
I5-5 (VA-) - H7-5 (AUXG) |
||
|
I5-6 (ADPG) - H7-4 (AUXO) |
||
|
I5-3 (VAL+) - Body ground |
Always |
10 kΩ or higher |
|
I5-2 (VAR+) - Body ground |
||
|
I5-5 (VA-) - Body ground |
||
|
I5-6 (ADPG) - Body ground |
(d) Reconnect the navigation receiver assembly connector.
(e) Reconnect the stereo jack adapter assembly connector.
|
|
|